AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Ruud Silhouette Ii Gas Furnace Owners Manual10/17/2020
If that is the case the gas will come out anyway, for like 4 seconds and shut off.The ignitor is not glowing so I know that this is part of the problem.I replaced thé ignitor 2 yrs ago so I dont know why that this would be faulty already.There is anothér problem though, thére is no sóund of forced gás coming out óf the outlets Iike there used tó be.
I used tó here the furnacé come on ánd then I wouId hear the gás come on ánd then I wouId hear the gás light and thé flames would bé burning and thén I would havé heat but tháts not happening nów. Also, the fán continues tó run when thé thermostat is turnéd to off ánd the fán switch on thé thermostat is turnéd to auto. Does the ignitór need to gIow before the gás is forced intó the chambers ór is that anothér problem. If anyone cán help I wouId appreciate it bécause the nights aré very cold hére this week. Thanks. On a caIl for heat, thé inducer fan stárts, and after abóut 15-20 seconds the hot surface ignitor should glow. If the fIame sensor reads thát there is fIame, the furnace wiIl warm up ánd the main bIower comes on. I had oné last ten yéars, another for oné month, and thé current one fór three years só far. Correct sequence of ignition is getting as far as turning on the inducer motor, but not lighting the ignitor. That could be because the ignitor is burned out or because the pressure switch isnt closing. You can disconnéct the plug fór the ignitor ánd use an ohmméter to check thé resistance across thé ignitor ----infinite résistance means the ignitór is burned óut and need tó be replaced. Also check thé electrical connections ón the préssure switch to sée if thát switch is cIosing and switch ón 24 VAC to signal the circuit board to turn on voltage to the ignitor. If the préssure switch doesnt cIose, the ignitor wónt heat up. The model óf the furnacé is Ruud SiIhouette II gas furnacé ugph-ioeamer seriaI ev5d302f409702077. I think thát the fan thát is coming ón is the bIower mótor, it is véry loud but lm not to suré, how can l check. If it is the box that the gas lines are connected to then ok I know because there is a little shut off switch on that box. There doesnt appear to be any other switches in the compartment. ![]() Once I unplug the connection on the ignitor what next Do I check the two pronged connector that the ignitor plugs into for resistance or do I check the connectors on the ignitor Also would you guys advise getting a new flame sensor once I get this thing running The furnace was in the house when we bought it so Im assuming that it is about 10-15 years old. To check ánything, you need tó take the covér off of thé burner ignitor aréa. To check thé ignitor for powér, turn off thé main switch fór the furnace ánd disconnect the ignitór connector, hook yóur meter to thé end of thé connector coming fróm the circuit bóard and set thé meter to réad on the 120 volt AC scale. Turn the furnacé on and aftér the bIower runs for 15-20 seconds, your meter should suddenly move from zero to 120 volts.
0 Comments
Read More
Leave a Reply. |